The patented FXR rotules series swivel fittings have been tested and certified by the Darmstadt University of Technology's Institute of Structural Analysis as well as by the French government Institute of Building : CSTB. The SADEV rotules have been approved by the CSTB and are certified with an "Avis Technique" The rotule fittings are designed to limit the stress around the drilled glass hole under wind pressure.
FXR 1001
Application : this rotule fitting is recommended for glass facade with a good access to the rear of the glass
Glass hole : countersunk. Bolt : standard M14 or M 16, length 65 mm.
Over lengths available on request
Drawing
Graphics Files
PDF pdf
DXF
FXR 1001A
Application : same as 1001 but for insulated glass. SADEV supplies also the aluminium gasket.
Glass hole : countersunk. Bolt : standard M14 or M 16, length 65 mm.
Over lengths available on request
Drawing
Graphics Files
PDF pdf
DXF
FXR 1101
Application : same as 1001 but with smaller dimensions
Glass hole : countersunk. Bolt : standard M14 or M 16, length 65 mm.
Over lengths available on request
Drawing
Graphics Files
PDF pdf
DXF
FXR 1003
Application : same as 1001 but with a cylindrical hole and is also used for glass canopies
Glass hole : cylindric. Bolt : standard M14 or M 16, length 65 mm.
Over lengths available on request
Drawing
Graphics Files
PDF pdf
DXF
FXR 1005
Application : this rotule fitting is recommended for suspended glass canopies and includes a silicon gasket.
Glass hole : cylindric. Bolt : standard M14 or M 16, length 65 mm.
Over lengths available on request
Drawing
Graphics Files
PDF pdf
DXF
FXR 1006
Application : this rotule fitting is used for blind glass canopies
Glass hole : cylindric. Bolt : standard M14 or M 16, length 65 mm.
Over lengths available on request
Drawing
Graphics Files
PDF pdf
DXF
FXR 1039
Application : this rotule is used for a double glazing where only the inner glass panel is drilled.The rotule body which is concealed in the glass is made of aluminium. Glass hole : cylindric. Bolt : standard M14 or M 16, length 65 mm.
Over lengths available on request
Drawing
Graphics Files
PDF pdf
DXF
FXR 1008
Application : this rotule fitting is used for blind glass wall.
Glass hole : countersunk. Bolt : standard M14 or M 16, length 65 mm.
Over lengths available on request
Drawing
Graphics Files
PDF pdf
DXF
Privacy Policy | Site Status | Employee Mail

Copyright © 2008 SADEV USA. All rights reserved.
Website by Triple Prism Consulting.